Moulding machine speed test and its Load Compensation Test
Moderator: BenTheMan
1 post
• Page 1 of 1
Moulding machine speed test and its Load Compensation Test
by tom.smart71 » April 17th, 2010, 7:36 pm
Hey Please help me i recently started Plastic Injection Molding machine.
doubts:
low injection speeds 5-15% can cause a test failure.
I am thinking about implementing linearity Test in Rgj. Please if u have some idea please do convey the same. State its load compensation testability.
doubts:
low injection speeds 5-15% can cause a test failure.
I am thinking about implementing linearity Test in Rgj. Please if u have some idea please do convey the same. State its load compensation testability.
- tom.smart71
- Posts: 2
- Joined: April 17th, 2010, 6:17 pm
- Location: Utah, USA
1 post
• Page 1 of 1
Who is online
Users browsing this forum: No registered users